 Products
|
Krisrepell
 |
Single pack silicone - water and oil repellent.
KRISREPELL is available in two grades. One grade is for a treatment of mineral substrates ie. facades of airfaced masonry and cement. Another grade is to improve oil and water resistance of hard stones,marbles, granites etc. Both the materials are ready to use chemically 'SILANE - SILOXANE' composition in a solvent media, forms a chemical structure similar to Quartz on application and reaction.
The cementitous - mineral building materials when comes in to contact with water, pollutant gases and carbon dioxide, they absorb water and results into a damage.The damages are like penetration of moisture, cracks due to swelling & shrinkage, frost & deicing salts, efflorescence and salt damage caused by hydration and crystallisation, lime leaching, rust stains, dirt pick up, attack by algae, fungi and moss & chemical corrosion of reinforcement steel yield to destruction of concrete.
BENEFITS
- Ready to use.
- Can be applied by brush, roller or spray.
- Very thin liquid - deep penetration.
- Drastic reduction in water absorption.
- Resistance to alkalies.
- No change in surface appearance - glossy, tacky or yellowing.
- Resistance to UV light.
- Bridges hairline crack for water repellency.
- Excellent water vapour diffusion.
- Non toxic - no health risk.
- Environmental friendly.
- Stops water seepage & leakage.
- No paint washout - protects paints.
- Prevents corrosion of reinforcement.
- Increases oil, water & stain resistance on absorbent minerals.
|
| Nature | Single pack | | Appearance & colour. | Very thin liquid, colourless to slight pale yellow colour. | | Clarity | Clear. | | Density | 0.80 ± 0.02gm / cc. | | Flash point | 38c. | | Coverage | Highly porous surface -25-30 sq.ft.per liter per coat. Poor absorbent surface eg.marble, granite, concrete, paints - 50-60 sq.ft.per liter per coat. | | Penetration depth | 1 - 3 mm. | | Water absorption | 2 - 5 % |
END USES
Protection of following substrates from water in exposed condition cement concrete, mineral plaster and paints,
sandstone, sand lime bricks, limestone, marble, granite, brick, jodhpuri andjaipuri stones.KRISREPELL is ideal for water repellency offacades and sloppy roof terrace
DIRECTION FOR USE
SURFACE PREPARATION
The surface shall be free from oil, grease and dirt. The surface shall be clean and dirt free, other wise dirt will get dissolved into solvent & will represent dirt stains. If possible wash the surface with clean water after thorough wire brushing. Allow the surface to dry for better penetration. The surface may be slightly damp but not wet.
APPLICATION
Apply two coats of KRISREPELL wet on wet by brush, roller or spray in a flooding way ie. the material shall
run down the substrate while application. The maximum the penetration the best performance it will provide. The perfomance can be tested only after drying for 24 hours or after 3 days.
CLEANING OF TOOLS
Clean the tools by white spirit, kerosene or xylene solvent.
STORAGE & SHELF LIFE
Shelf life is one year from the date of manufacture. Store the material in cool & dry place away from sun heat.
|
|
